User guide

Installation and Wiring

138

Step Action

1 Place the GP unit on a clean and level surface with the display facing

downward.

2 Check that the GP unit’s gasket is seated securely into the gasket’s groove,

which runs around the perimeter of the GP unit frame.

3 Cut a hole in the installation panel as defined by the GP unit’s panel cutout

dimensions.

GP-4200 Series (see page 63)

GP-4300 Series (see page 81)

GP-4400 Series (see page 96)

GP-4500 Series (see page 116)

GP-4600 Series (see page 133)

4 Insert the GP unit into the panel-cut.

5 Insert the installation fasteners into the GP unit’s insertion slots on the top and

bottom sides (left and right sides for the GP-4200 Series). Slide the fasteners

to the back. If the fasteners are not correctly attached, the GP unit may shift or

fall out.

GP-4301T

GP-4201T

Installation Panel

Hook

Slots