Manual

Packing List
Attachmen x1
Gasket x1
M4 Hex nut x10 (two spares)
Installation Procedures
Installation Guide
C
Copyright 2004 Digital Electronics Corporation.All rights reserved.
Step 1. Confirm the Display unit (1), four installation fasteners (5) and
moisture resistant gasket (2) are present.
Step 2. Make sure that the moisture resistant gasket is fitted properly to
the Display unit.
Step 3. Install the gasket (4) to the attachment (3) correctly.
Step 4. Attach the Display to the attachment prepared in Step 3 by
using the installation fasteners.
Tighten the fastener attachment
screws. The proper torque for tightening a screw to obtain a
sufficient level of splash-proof is 0.5 N•m.
Step 5. Insert the attachment prepared in Step 4 in to the cutout section
of the operation panel of the
target model
by matching the
threaded portion of the plate with the four corners of the panel.
Step 6. Confirm the gasket is installed correctly.
Step 7. Tighten the M4 hex nuts (6) evenly. The proper torque for
tightening a nut to obtain a sufficient level of splash-proof is
0.5 N•m.
Head Office
Digital Electronics Corporation
8-2-52 Nanko-higashi
Suminoe-ku, Osaka 559-0031 JAPAN
Tel: [phone]
Fax: [phone]
URL:http://www.pro-face.com/
We assume no
responsibility for any
losses, damages or any
claims from third party
resulting from the use of
this product.
Disclaimer
Silver metallic
Item Specified Values
Inst allat ion Requirement s
Protective
Construction
Protection: Equivalent to IP65
(Front face of installed unit)
Weight
0.45 kg or less (Attachment only)
External Dimensions
(W)x(H)x(D)
[
mm ]
317.0 x 243.0 x 17.0
Color
Material
Steel plate
227.5mm
201mm
301.5mm
259mm
Finestra
Finestra
Completed Chart
(1)
(3)
(4)
(6)
(5)
(2)
Main unit and accessories
•
Display unit x1
••••••••••
(1) Option
•
Moisture resistant gasket x1
•••
(2) Option
•
Accessories of Display
•
Attachment x1
•••••••••••
(3)
•
Gasket x1
••••••••••••••
(4)
•
Installation fastener x4
••••••
(5) Option
•
Accessories of Display
•
M4 Hex nut x8
•••••••••••
(6)
(2)
Magnified View
Panel Cutout Adapter(CA4-ATM10-01)
Introduction
AGP-35*0T
ST-3500 series
GP-2500 series
When the product is disposed of, it should be done so according to your country's
regulations for similar types of industrial waste.
GP-2600 series
Do not over
-tighten the hex nuts or the
attachment may be damaged.
screws or Display may be damaged.
Do not over-tighten the fastener attachment
This product is a conversion kit for replacing the current
display unit manufactured by Pro-face with a display unit
that has smaller panel cutout dimensions.
Before
After
“Before”
“After”
GP-4500 series
A global code is assigned to every Pro-face product as a
universal model number.
For more information on product models and their matching
global codes, please refer to the following URL.
http://www.pro-face.com/product/globalcode.html