User guide

8
*1
The CD, DTR, and DSR are connected together inside of the FP.
Connector.................. Dsub 9 pin female
Connector set screw.. Inch type (4-40)
Cable......................... SIO cable for FP manufactured by Pro-face.
(FP61V-IS00-O)
Concerning Signal Names
Signal names used for the serial interface on FP units are designed to match the pin order
used on most PC serial interfaces, so that a straight cable can be used to connect the two.
Therefore, connect each pin’s signal to the same signal name on the PC side.
For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the PC’s
connector.
Refer to the FP-3710T series User Manual’s section “Cable Diagrams” for each signal’s
direction.
 USB Interface (Type-B connector : Up-Stream Port)
Pin Assignments and Signal Names for USB Interface
Cable......................... USB cable manufactured by Pro-face.
(FP-US00)
(1) According to the Panel Cut size, make instllation holes on the panel.
Pin No. Signal Name Condition Pin Location
1 USB1-5V +5VIN
2 USBD1(-) USB data(-)
3 USBD1(+) USB data(+)
4 GND Ground
• If a cable other than the specified USB cable is used, product
performance cannot be guaranteed due to the possibility of noise
interfering with the FP unit’s operation.
5 Instllation
4
3
2
1
FP
Unit: mm [in]
383.5 [15.1 ]
+1
0
+0.04
0
282.5
+1 0
[11.12 ]
+0.04 0
under 4-R3[0.12]
FP
Panel
Panel thickness
1.6[0.06] to
10[0.39]