User guide

7
Pin Assignments and Signal Names for DVI-D
Connector.................. DVI-D 24-pin male
Connector set screw.. Inch type (4-40)
Cable......................... DVI-D cable manufactured by Pro-face.
(FP-DV01-50 <5 m>, FP-DV01-100 <10 m>)
 Serial Interface
Pin Assignments and Signal Names for Serial Interface
*1.
When you use this resolution, set “ON” for “720 × 400 Mode” in the OSD (On
Screen Display) “System Settings”.
Pin No Signal Name Pin No Signal Name Pin Location
1 TMDS DATA2- 13 NC
2 TMDS DATA2+ 14 NC
3 TMDS DATA2 SHIELD 15 GND
4 NC 16 Hot Plug Detect
5 NC 17 TMDS DATA0-
6 DDC Clock 18 TMDS DATA0+
7 DDC Data 19 TMDS DATA0 SHIELD
8NC20NC
9 TMDS DATA1- 21 NC
10 TMDS DATA1+ 22 TMDS CLOCK SHIELD
11 TMDS DATA1 SHIELD 23 TMDS CLOCK+
12 NC 24 TMDS CLOCK-
• If a cable other than the specified DVI-D cable is used, product
performance cannot be guaranteed due to the possibility of noise
interfering with the FP unit’s operation.
• The FP-DV01-100 can be used only when connected to a PS-2000B unit.
When using the FP-DV01-100, be sure to turn the PS-2000B’s internal
dipswitch 4 ON.
(When using the FP-DV01-50, turn this switch OFF.)
RS-232C Serial Interface
Baud rate : 9600 bps
Data length : 8 bits
Parity : None
Stop bit : 1
Flow Control: None
Pin No. Signal Name Condition Pin Location
1 CD Carrier Detect
*1
2 RD Receive Data (FP->Host)
3 SD Send Data (FP<-Host)
4 DTR Data Terminal Ready
*1
5 GND Ground
6 DSR Data Set Ready
*1
7 RS Request to Send (FP<-Host)
8 CS Clear to Send (FP->Host)
9 NC (Used internally)
1 9
17
8
16 24
17
24
1
8
6
9
1
5