User guide

11
 Connecting the Power Cord
When connecting the AC type power cord, be sure to follow the procedures given below.
(1) Confirm that the power cord is unplugged from the power supply.
(2) Push the Opening button by a small and flat screw driver to open the desired pin
hole.
(3) Insert each pin terminal into its each hole. Release the Opening button to clamp the
pin place.
(4) After inserting all three pins, insert the Power Plug into the Power Connector at FP.
Fix the plug with two(2) minus screws.
.
 USB Cable Clamp Attachment Procedure
Installation to USB cable
(1) Connect the USB cable to the connector.
(2) Tighten the clamp until the cable is secured in place and insert the convex of cable
clamp into the USB fixing hole to fix both as shown in the following figure.
USB Cable Clamp Removal Feature
(1) Push in the cable clamp's stopper with a standard flat-blade screwdriver until the
cable clamp is unlocked, and remove it.
(2) Disconnect the USB cable.
• Confirm that all wires are connected correctly.
• The torque required to tighten these screws is 0.5N•m to 0.6N•m.
• To prevent the possibility of a terminal short, use a pin terminal that
has an insulating sleeve.
7 Using the USB Cable Clamp
L
N
FG
AC power supply cord
Green/Yellow
White
Black
Opening Button
USB cable clamp
USB Cable
Stopper
USB cable clamp holder