User guide

10
 Environmental Specification
 Power Cord Specifications
Use copper conductors only.
*1 If the Conductor
’s end (individual) wires are not twisted correctly, the
end wires may either short against each other, or against an electrode.
 Power connector specification
Use the following wiring for FP. Those are Phoenix Contact products.
Voltage Endurance
AC1500V 20mA for 1 minute
(between charging and FG terminals)
Insuration Resistance
DC500V 10M
Ω (Min.)
(between charging and FG terminals)
Item Specification
Surrounding Air
Temperature
0~50ºC (The panel should not incline more than 30º)
Storage Temperature -20 ~ +60ºC
Ambient Humidity
10~90%RH
(No condensation, Wet bulb temperature: 39ºC max.)
Storage Humidity
Air Purity (Dust) 0.1mg/m
3
(Max.) (No electrically conductive dust is allowed)
Pollution Degree Pollution Degree 2
Power Cord Diameter
0.2mm
2
to 2.5mm
2
[0.0001 to
0.0097inch
2
] (24AWG to 12 AWG)
Conductor Type Simple or Twisted Wire
*1
Conductor Length
L
AC Input Terminal-live line
N AC Input Terminal-neutral line
FG Ground Terminal connected to the FP chassis
• Kind of power cord is FKC 2,5/3-STF-5,08 which are Phoenix
Contact products.
Recommended Drivers SZS 0.6X3.5 (1205053)
Recommended stick end
terminal
AI 0.34-12TQ(3200645) AI 0.5-10WH(3201275)
AI 0.75-10GY(3201288) AI 1-10RD(3200182)
AI 1.5-10BK(3200195) AI 2.5-12BU(3200962)
Crimp tool for recommended
stick end terminal
CRIMPFOX ZA 3 (1201882)
10mm [0.39 in.]
FG
N
L
Power Cable Joint