Manual

Pin Assignments and Signal Names for Serial Interface

The CD, DTR, and DSR are connected together inside of the FP.

Connector ......................Dsub 9 pin female

Connector set screw......Inch type (#4-40 UNC)

Cable .............................SIO cable for FP manufactured by Pro-face.

(FP61V-IS00-O)

Concerning Signal Names

Signal names used for the serial interface on FP units are designed to match the pin

order used on most PC serial interfaces, so that a straight cable can be used to

connect the two. Therefore, connect each pin’s signal to the same signal name on

the PC side.

For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the PC’s

connector.

Refer to the FP-3710K Series User Manual’s section “Cable Diagrams” for each

signal’s direction.

 USB Interface (Type-B connector : Up-Stream Port)

Pin Assignments and Signal Names for USB Interface

Cable ..................... USB cable manufactured by Pro-face.

(FP-US00)

(1) According to the Panel Cut size, make installation holes on the panel. Also,

determine the panel thickness according to the panel thickness range with due

consideration of panel strength.

Pin No. Signal Name Condition Pin Location

1 CD Carrier Detect

2 RD Receive Data (FP->Host)

3 SD Send Data (FP<-Host)

4 DTR Data Terminal Ready

5 GND Ground

6 DSR Data Set Ready

7 RS Request to Send (FP<-Host)

8 CS Clear to Send (FP->Host)

9 NC (Used internally)

Pin No. Signal Name Condition Pin Location

1 USB1-5V +5VIN

2 USBD1(-) USB data(-)

3 USBD1(+) USB data(+)

4 GND Ground

• If a cable other than the specified USB cable is used, product

performance cannot be guaranteed due to the possibility of

noise interfering with the FP unit’s operation.

5 Installation