Manual

5
 SW1
• SW1-2 Dip Switch SW1-2 is used to display or hide the OSD.
To hide the OSD, set the switch to ON. To display the OSD, set the switch to OFF.
The default setting is OFF. (OSD is displayed.)
 SW2
 Analog RGB Interface
The number of dots (pixels) displayed are as follows:
Switch Setting
SW1-1 Reserved (Always OFF) SW1-5 Reserved (Always OFF)
SW1-2 Display/Hide the OSD SW1-6 Reserved (Always OFF)
SW1-3 Reserved (Always OFF) SW1-7 Reserved (Always OFF)
SW1-4 Reserved (Always OFF) SW1-8 Reserved (Always OFF)
Switch Setting
Slide Switch is used to switch the data input/output
(command control) method on the touch panel between
USB and RS-232C (Serial). The default setting is USB.
4 Interfaces
Input signal type Analog RGB
Input signal
characteristic
Image signal : analog RGB
Synchronous signal :TTL level, negative true or positive true
Scanning type : non-interlace
Setting by OSD
(On Screen Display)
•CONTRAST
•H-POSITION
•H-size
•DIMMER(BACKLIGHT)
•ALL RESET (DEFAULT)
•BRIGHTNESS
•V-POSITION
•PHASE
•SHARPNESS
Size
H Sync.
(kHz)
V Sync.
(Hz)
Dot Clock
(MHz)
Screen Resolution
Expansion
(H: Horizontal)(V: Vertical)
Display
Resolution
640×400 24.827 56.000 21.053
×1.6 (H)
×1.92 (V)
1024×768
640×400 31.469 70.000 25.175
640×480 31.469 59.992 25.175
×1.6640×480 37.500 75.000 31.500
640×480 35.000 66.667 30.240
720×400
*1
*1
When you use this resolution, set “ON” for “720 × 400 Mode” in the OSD
(On Screen Display) “System Settings”.
31.469 70.000 28.320
×1.42 (H)
×1.92 (V)
800×600 37.879 60.317 40.000
1.28
800×600 46.875 75.000 49.500
1024×768 48.363 60.004 65.000
1.01024×768 56.476 70.069 75.000
1024×768 60.023 75.029 78.750
1 2 3 4 5 6 7 8
ON
USB
232