Manual

10
 Electrical Specification
 Environmental Specification
 Power Cord Specifications
Use copper conductors only.
*1 If the Conductor
’s end (individual) wires are not twisted correctly, the
end wires may either short against each other, or against an
electrode.
 Power connector specification
Item Specification
Power Supply
Rated Voltage AC100V ~ AC240V
Allowable Voltage AC85V ~ AC264V
Rated Frequency 50 / 60HZ
Allowable Frequency Range 40Hz - 72Hz
Allowable Voltage Drop
1cycle or less (Voltage drop interval must be 1s
or more.)
Current Consumption
AC100V 1.1A or less (TYP 0.75A)
AC240V 0.7A or less (TYP 0.44A)
In-Rush Current 60A (Max.)
Voltage Endurance
AC1500V 20mA for 1 minute
(between charging and FG terminals)
Insulation Resistance
DC500V 10MΩ (Min.)
(between charging and FG terminals)
Item Specification
Surrounding Air
Temperature
0 ~ 50ºC (The panel should not incline more than 30º)
Storage Temperature -20 ~ +60ºC
Ambient Humidity
10 ~ 90%RH
(No condensation, Wet bulb temperature: 39ºC max.)
Storage Humidity
Air Purity (Dust) 0.1mg/m
3
(Max.) (No electrically conductive dust is allowed)
Pollution Degree For use in Pollution Degree 2 environment
Power Cord Diameter 0.75mm
2
to 2.5mm
2
(18AWG to 12 AWG)
Conductor Type Simple or Twisted Wire
*1
Conductor Length
L
AC Input Terminal-live line
N
AC Input Terminal-neutral line
FG
Ground Terminal connected to the FP chassis
10mm [0.39 in.]
FG
N
L
Power
Cable
Joint