Manual

FP-3710K Series User Manual
10-4
• The gasket must be inserted correctly into the groove for the FP unit’s moisture
resistance to be equivalent to IP65f.
• Since the gasket is flexible but not elastic, be careful not to stretch it
unnecessarily, as doing so could tear the gasket.
• Be sure the gasket's seam is not inserted into any of the unit's corners, only in the
straight sections of the groove. Inserting it into a corner may lead to its eventually
tearing.
• Install the gasket as it comes to the under side of the display area. Otherwise it
could not sufficiently prevent from dust and water.
• The upper surface of the gasket should protrude approximately 2mm out from the
groove. Be sure to check that the gasket is correctly inserted before installing the
FP into a panel.
unit: mm