Instruction Manual

 Serial Interface

Pin Assignments and Signal Names for Serial Interface

The CD, DTR, and DSR are connected together inside of the FP.

Connector ..................... Dsub 9 pin female

Connector set screw ..... Inch type (#4-40UNC)

Cable............................. SIO cable for FP manufactured by Pro-face.

(FP61V-IS00-O)

Concerning Signal Names

Signal names used for the serial interface on FP units are designed to match the

pin order used on most PC serial interfaces, so that a straight cable can be used

to connect the two. Therefore, connect each pin’s signal to the same signal name

on the PC side.

For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the

PC’s connector.

Refer to the FP3000 Series User Manual’s section “Cable Diagrams” for each

signal’s direction.

 USB Interface (Type-B connector : Up-Stream Port)

Pin Assignments and Signal Names for USB Interface

Cable............................. USB cable manufactured by Pro-face.

(FP-US00)

RS-232C Serial Interface

Baud rate : 9600 bps

Data length : 8 bits

Parity : None

Stop bit : 1

Flow Control: None

Pin No. Signal Name Condition Pin Location

1 CD Carrier Detect

2 RD Receive Data (FP->Host)

3 SD Send Data (FP<-Host)

4 DTR Data Terminal Ready

5 GND Ground

6 DSR Data Set Ready

7 RS Request to Send (FP<-Host)

8 CS Clear to Send (FP->Host)

9 NC (Used internally)

Pin No. Signal Name Condition Pin Location

1 USB1-5V +5VIN

2 USBD1(-) USB data(-)

3 USBD1(+) USB data(+)

4 GND Ground

• If a cable other than the specified USB cable is used, product

performance cannot be guaranteed due to the possibility of

noise interfering with the FP unit’s operation.