Instruction Manual

Pin Assignments and Signal Names for Serial Interface

Connector...........................Dsub 9 pin female

Connector set screw ..........#4-40 UNC

Cable..................................SIO cable for FP manufactured by Pro-face.

(FP61V-IS00-O)

Concerning Signal Names

Signal names used for the serial interface on FP units are designed to match the pin order used

on most PC serial interfaces, so that a straight cable can be used to connect the two. Therefore,

connect each pin’s signal to the same signal name on the PC side.

For example, pin #2 ‘RD’ should be connected to the ‘RD’ input terminal on the PC’s connector.

Refer to the FP3000 Series User Manual’s section “Cable Diagrams” for each signal’s direction.

 USB Interface (Type-B connector : Up-Stream Port)

Pin Assignments and Signal Names for USB Interface

Cable..................................USB cable manufactured by Pro-face.

(FP-US00)

Pin No. Signal Name Condition Pin Location

1 CD Carrier Detect

*1 The CD, DTR, and DSR are connected together inside of the FP.

2RD

Receive Data (FP->

Host)

3 SD Send Data (FP<-Host)

4 DTR Data Terminal Ready

5 GND Ground

6 DSR Data Set Ready

7RS

Request to Send (FP<-

Host)

8CS

Clear to Send (FP->

Host)

9 NC (Used internally)

Pin No. Signal Name Condition Pin Location

1 USB1-5V +5VIN

2 USBD1(-) USB data(-)

3 USBD1(+) USB data(+)

4 GND Ground

• If a cable other than the specified USB cable is used, product

performance cannot be guaranteed due to the possibility of

noise interfering with the FP unit’s operation.