User Manual

8
 USB Interface (Type-B connector : Up-Stream Port)
Pin Assignments and Signal Names for USB Interface
Cable............................. USB cable manufactured by Pro-face. (FP-US00)
(1) According to the Panel Cut size, make installation holes on the panel. Also,
determine the panel thickness according to the panel thickness range with
due consideration of panel strength.
(2) Check that FP has installation fasteners. Insert the FP from the front.
Pin No. Signal Name Condition Pin Location
1 USB1-5V +5VIN
2 USBD1(-) USB data(-)
3 USBD1(+) USB data(+)
4 GND Ground
• If a cable other than the specified USB cable is used, product
performance cannot be guaranteed due to the possibility of
noise interfering with the FP unit’s operation.
Installation
FP X Y Panel thickness
FP-3710T Series
383.5
[15.10 ]
282.5
[11.12 ]
1.6 [0.06] to
10.0 [0.39]
• Installation gasket must be used even though it is not
necessary for its environment. For installation, refer to the
FP3000 Series User Manual.
• Check that the installation panel or cabinet's surface is flat, in
good condition and has no jagged edges. Also, if desired,
metal reinforcing strips can be attached to the inside of the
panel, near the Panel Cut, to increase the panel's strength.
4
3
2
1
Unit: mm [in]
Y
X
r ≤ 3[0.12]
Panel
thickness
FP
+1.0
-0
+1.0
-0
+0.04
-0
+0.04
-0