User Manual

4
The Dip Switches and Slide Switch are located in the bottom of the FP unit. Only
the settings when the power supply is turned on is effective to the Dip Switches
and the Slide Switch. Turn off the power before changing the settings of this unit.
 SW1
• SW1-2 Dip Switch SW1-2 is used to display or hide the OSD.
To hide the OSD, set the switch to ON. To display the OSD, set the switch to
OFF.
The default setting is OFF. (OSD is displayed.)
 SW2
Dimensions
Dip Switches and Slide Switch
Switch Setting
SW1-1 Reserved (Always OFF) SW1-5 Reserved (Always OFF)
SW1-2 Display/Hide the OSD SW1-6 Reserved (Always OFF)
SW1-3 Reserved (Always OFF) SW1-7 Reserved (Always OFF)
SW1-4 Reserved (Always OFF) SW1-8 Reserved (Always OFF)
Switch Setting
Slide Switch is used to switch the data input/output
(command control) method on the touch panel between
USB and RS-232C (Serial). The default setting is RS-
232C.
383 [15.08]
60 [2.36]
395 [15.55]
282 [11.10]
294 [11.57]
5 [0.20]
Top View
Front View
Side View
Unit: mm [in]
Dip Switches(SW1)
Slide Switch(SW2)
Bottom View
1 2 3 4 5 6 7 8
ON
USB
232