User Manual

12
(2) Insert the cable clamp into the
cable clamp holder as shown in
the following figure, and tighten
the clamp until the cable is
secured in place.
USB Cable Clamp Removal
Feature
(1) Push in the cable clamp’s
stopper until the cable clamp is
unlocked, then remove the
clamp.
(2) Disconnect the USB cable.
Please pay special attention to the
following instructions when
connecting the power cord terminals
to the FP unit.
• If the power supply voltage
exceeds the FP unit’s specified
range, connect a voltage
transformer.
• Between the line and the ground,
be sure to use a low noise power
supply. If there is still an
excessive amount of noise,
connect a noise reducing
transformer.
• Input and Output signal lines must
be separated from the power
control cables for operational
circuits.
• The FP unit’s power supply cord
should not be bundled with or kept
close to main circuit lines (high
voltage, high current), or input/
output signal lines.
• Connect a surge absorber to
handle power surges.
• To reduce noise, make the power
cord as short as possible.
• The temperature rating of field
installed conductors: 75 ºC only.
• Must be used with a Class2
Power Supply.(FP3710-T42-24V-
U)
When attaching a wire to the FP
unit’s rear face FG terminal, (on the
AC Connector), be sure to create an
exclusive ground.
(Use a grounding resistance of
100Ω, a wire of 2mm
2
or thicker, or
your country’s applicable standard.)
• All FP Input and Output signal
lines must be separated from all
operating circuit (power) cables.
• If this is not possible, use a
shielded cable and ground the
shield.
 OSD Functions
You can operate the FP screen
menus via the touch panel, and even
if FP is operating, adjust screen
image display to a minute level. The
feature is called OSD (On Screen
Display). The items that can be set
with OSD and the functions are
shown.
Power Supply Cautions
USB cable
clamp
USB
Cable
Stopper
USB cable
clamp holder
Grounding Caution
Input/Output Signal Line
Cautions
Calibration of OSD Display
Position
Example of OSD screen
"Ver.*.**" indicates
the version of the
OSD.