Owner manual

The cable clamp is used to hold excess cable in place and pre-

vent the cable from being caught and possibly damaged. Be sure

to insert extra cable in the cable clamp before replacing the rear

cover.

10) Replace the PS-A unit’s rear cover and secure it in place using the five (5) attach-

ment screws. (PS-3701A and FP-3700T units have eight (8) screws each.)

After backlight replacement is completed, turn the PS-A/FP unit’s power ON and

check if the screen’s display is normal. If the display is not correct, please con-

tact the Pro-face distributor from whom you purchased the backlight unit.

9) Replace the FDD unit in its original position and secure it in place using the two

(2) attachment screws. The neccesary torque is 0.5N•m to 0.6N•m. Reconnect

the FDD unit cable and power cable (opposite of step (2)).

(PS-3700A only)

CA3-BLU15-MT01-CP 2003.12

Note

Regardless of the above clause, Digital Electronics Corporation

shall not be held responsible for any damages or third-party claims

for damages or losses resulting from the use of this product.

Digital Electronics Corporation

8-2-52 Nanko Higashi, Suminoe-ku, Osaka 559-0031, Japan

URL: http://www.pro-face.com/

6) Insert each new backlight unit into its backlight holder.

8) Connect each new backlight’s power cable connector to the Inverter board’s

backlight connector. Position the excess cable in place inside the cable clamp,

and cover the cable and connector with the Inverter Insulation Sheet. (opposite of

step (3))

Be sure the cable is inserted completely into the backlight con-

nector. Failure to do so may cause arcing, which can damage the

connector.

Be sure to always change both PS-A unit backlights at the same

time.

7) Secure both backlights in place using the backlight set screws (opposite of step

(4)). The neccesary torque is 0.147N•m (1.5kgf•cm).