Owner manual

3
3) Bend the Inverter’s Insulation Sheet
back to expose the backlight’s power
cable and connector. Next, free the
excess cable from the cable clamp and
expose the cable connector. Hold the
power cable connector and pull it out
of the backlight power connector.
4) Insert a screwdriver each of the two
holes (points) shown at right, and
remove each backlight set screw (1 per
hole).
5) Pull out the backlight power cable in
the direction shown by the arrow. The
backlight unit will then detach from the
backlight unit holder.
The entire backlight unit
should be changed, not only
the backlight.
Power
Cable
Power Cable Clamp
Backlight Power Connector
Inverter Insulation Sheet
Power
Cable
Backlight Unit
Backlight Unit Insertion Groove
Insert a
screwdriver
here