User Manual

PS-3710A/PS-3711A Series Hardware Manual

2-30

 Switches

The following switch settings corresponding to each Serial Interface need to be signi fied. To set the switches

which are on the PS-A’s circuit board, remove the PS-A’s Rea r Cover. Please refer to 3.2.1 Removal/

Attachment the Rear Cover (page 3-6). The switches are locat ed as follows;

Switch

Location

Switch Name

Compatible

I/F

Factory

Settings

Description

A Serial Mode Select SW COM2

All OFF

(RS-232C)

10-point dip switch. Designates COM2

communication settings. For Serial Mode

Select SW details, see Table (2).

B System Set SW -

See

Table (1)

10-point dip switch . For System Set SW and

the factory settings details, see Table (1).

C RI/+5V Changeover SW COM1 RI Changes # 9 pin (RI <---> +5V).

1010

123456789123456789

Inside of the rear