User Manual

PL3000 Series Hardware Manual
2-10
W: Disk access lamp (DISK)
X: Serial interface (COM1)
D-Sub 9-pin plug type.
RS-232C, RS-422, RS-485 Changeover.
CI (RI)/+5V Changeover.
Y: Serial interface (COM2)
D-Sub 9-pin plug type.
RS-232C.
CI (RI)/+5V Changeover.
Z: Serial interface (COM3/COM4)
D-Sub 9-pin plug type.
RS-232C.
COM3 and then COM4 from the top
a: RAS interface (RAS)
D-Sub 9-pin socket type.
b: CF Card interface (CF CARD)
IDE-type connection
*1
.
CF Card (Type I/II) compatible is available.
c: Fan cover
System fan inside
d: System fan
A fan for cooling the PL unit
e: Power connector
f: Power switch
AC type only.
LED Indicates
Green (lit)
When HDD/SSD or IDE is
accessed
Not lit
When neither HDD/SSD nor
IDE is accessed
*1 Since an IDE-type connection is used, the unit is not hot-swappable. When inserting/removing the
CF Card, be sure that power is turned OFF.
• When attaching peripheral units to the PL, be sure the PL’s power cord is
disconnected from the main power supply.
Bottom
(PL-3600K Series 2 slot type)
c
e
f
d
N
Q
R
Right side
(PL-3600K Series 2 slot type)
T
U
X
Y
b
a
V
W
V
A
O
P
Z
S
Top
(PL-3600K Series 2 slot type)
R