User Manual

PL3000 Series Hardware Manual
7-2
7.1 DVD Drive Unit
This section provides information on the PL unit in which our DVD drive unit or DVD multi drive unit is
built-in.
7.1.1 Specifications
 Performance Specifications
 Environmental Specifications
The specification value s in the tabl e below are those when the DVD drive unit is built-in to the PL unit.
• Do not remove the DVD drive unit from the DVD drive unit.
DVD-ROM drive type DVD multi drive type
Supported
media
CD/DVD-ROM, DVD-VIDEO
CD/DVD-ROM, DVD-VIDEO, CD-R/RW,
DVD-R/-RW, DVD+R/+RW, DVD-RAM
Reading speed CD: Max. 24x / DVD: Max. 8x
Interface Connected to the slave IDE/ATAPI.
DVD-ROM dr ive type DVD multi drive typ e
Physical
Surrounding Air
Temperature
5 to 50°C
5 to 50°C : reading
5 to 45°C : writing
Storage Temperature -20 to +60°C
Ambient Humidity
10 to 90%RH
(Not condensing, wet bulb temperature: 29°C or less.)
Storage Humidity
10 to 90%RH
(Not condensing, wet bulb temperature: 39°C or less.)
Mechanical
Vibration Resistance
*1
*1 DVD drive unit to spin the disk, the Vibration Resistance is 1.96m/s
2
during DVD drive unit's
read/write running.
Without HDD
IEC/EN61131-2 compliant
5 to 9 Hz single-amplitude 3.5mm [0.14in.]
9 to 150 Hz const a nt-accelerati o n 9. 8m/s
2
X, Y, Z directions for 10 cycle (100 minute)
With HDD
10 to 57 Hz single -amplitude 0. 07 5 mm [0 .0 0 3i n .]
57 to 150 Hz constant-acceleration 9.8m/s
2
X, Y, Z directions for 10 cycle (80 minute)
Electrical
Noise Immunity
Noise Voltage: 150 0V
P-P
Pulse Duration: 50ns, 500ns, 1µs
Rise Time: 1ns
(via noise simulator)
Electrostatic Discharge
Immunity
6kV (complies with IEC/EN 61000-4-2 Level 3)