User Manual

Chapter 3 PL Monitoring Features
3-23
 List of Device Addresses
*1 When monitoring the voltage with the device monitor, the unit is “mV”.
*2 When monitor ing the number of revolutions with the device monitor, the unit is “rpm”.
*3 When monitoring Temperature with the device monitor, the unit is “°C”.
*4 Used for only the system to read/write the data and perform monitoring operation.
*5 Shuts down and restarts the operation system on the client PL.
*6 Indica tes the error event that is bein g monitored by the PL.
Device
Device
Type
Device
Symbol
Read/
Write
Bit Access
16-bit
Access
32-bit
Access
VcoreA *
1
WORD
VLT
Read
-
VLT0
-
VcoreB *
1
WORD VLT1
+3.3V *
1
WORD VLT2
+5.0V *
1
WORD VLT3
+12V *
1
WORD VLT4
+1.8V *
1
WORD VLT5
-12V *
1
WORD VLT6
Number of Revolution
of CPU FAN *
2
WORD
FAN
FAN0
Number of Revolution
of System FAN
WORD FAN1
System Temperature *
3
WORD
TMP
TMP0
CPU Temperature *
3
WORD TMP1
System2 Temperature*
3
WORD TMP2
DIN WORD DIN DIN00-DIN01 DIN0
DOUT WORD DOUT
Read/Write DOUT00-DOUT01 DOUT0
Error Event WORD ERR Read ERR00 - ERR10
ERR0
ERR1
Internal Memory Area *
4
WORD LS
Read/Write
LS00000-LS0000F
to
LS02550-LS0255F
LS0000
to
LS0255
LS0000
to
LS0254
Shared Memory WORD PL
PL00000-PL0000F
to
PL02550-PL0255F
PL0000
to
PL0255
PL0000
to
PL0254
Software Reset Port *
5
WORD RST - RST0 -
Error Mask *
6
WORD ERRM Read ERRM00-ERRM10
ERRM0
ERRM1
-
• The client PL can be shut down/restarted by writing the following values to the
Software Reset Port. When "Forced Shutdown" or "Forced Reboot" is written to the
device address, the system automatically shuts down/restarts the operation system
without prompting the confirmation for saving the data of currently running
application programs. Take extra cautions when performing write operations so as
to avoid accidental data loss.