User Manual

Chapter 2 System Setup
2-19
AHCI Configuration
Specifies whether to use the AHCI mode for SATA. When [SATA Operational Mode] is [Compatible], this
option is not displayed.
[Enabled] Uses AHCI mode.
[Disabled] Does not use AHCI mode.
ComINIT OOB-sequence issue
Specifies whether to use an Inte l BIOS Spec. 2.0. When [SATA Operation Mode] is [Compatible], or when
[AHCI Configuration] is [Disabled], this option is not displayed.
[Enabled] Uses Intel BIOS Spec. 2.0.
[Disabled] Does not use Intel BIOS Spec. 2.0.
LAN Controller 1
Displays the enabled/disabled status of the LAN controller 1.
[Enabled] Indicates that LAN controller 1 is enabled.
[Disabled] Indicates that LAN controller 1 is disabled.
LAN Controller 2
Specifies whether to use the LAN controller 2.
[Enabled] Uses the LAN controller 2.
[Disabled] Does not use the LAN controller 2.
High-Definition Audio (Azalia)
Specifies whether to use the HD audio feature.
[Auto] Uses the HD audio feature.
[Disabled] Does not use the HD audio feature.
• When installing the OS with [AHCI Configuration ] set to [Enable], dow nload Intel
Matrix Storage Manager from the Pro-face support site “Otasuke Pro!”. For the
detailed installation procedure, refer to the “Otasuke Pro!” site.
http://www.pro-face.com/otasuke/
• In AHCI mode, be sure to use an Intel-manufactured AHCI driver. When installing Windows
Vista (not supported OS) on the SATA drive (in AHCI mode) on user authority, using a
Microsoft-manufactured AHCI driver (which is included in the Vista Installer) causes the PL to
hang up during the OS start-up process for installing.
If you use a Microsoft-manufactured AHCI driver accidentally, ch ange this setting to [Disabled]
to install an Intel-m anufa ct u red AHCI driver, and then reset the setting to [Enabled].