User Manual

PL3000 Series Reference Manual
2-12
Power-ON Configuration
Specifies the PL operations at power-on. Point the cursor to [Power-ON Configu ration] on the [Advanced]
menu and press the [Enter] Key to display the following screen.
Power On Delay
Specify whether to set standby time before the system starts up.
[Enabled] The system waits for 4 seconds before start-up.
[Disabled] The system starts up normally.
Restore Main Power
Specifies the operation when the ma in power is turne d to ON. When [Power on Delay] is [Enabled], this
option is not displayed.
[Stay Off] The PL unit does not start when the reset switch is turned to ON.
It starts when the reset switch is pressed.
[Power On] The PL unit starts when the main power is t urne d to ON.
If a USB device such as USB memory is connected to the PL when the PL is started, the follow-
ing phenomenon may occur, depending on the device:
It takes about 1 minute before the OS starts up.
The PL does not recognize the USB device.
These problems may be solved by setting [Power On Delay] to [Enable].
Normally, specify [Power On] for use.
When you change the setting to [Stay off], launch the OS again without turning the main power
OFF.