User Manual

Chapter 3 PL Monitoring Features
3-41
SSD/CF Status
Selecting [SSD/CF Status] displays the [SSD/CF Status] dialog box, which
allows confirmation of remaining product life.
Remaining product life is calcul ated according to the number of write
operations made to the SSD, and is displayed as a percentage value with
one decimal place.
• Monitoring of SSD life is only possible on pre-installed OS type PL units that
have SSD units. PL units do not support monitoring of CF card life.
• Monitoring of SSD card life is only possible with SSD units that have been
subjected to an operational inspection by Digital Electronics Corporation.
• When remaining life bec omes 0.0%, the alert set in [Alert Acti on] under [System
Monitor Property] is generated.
When the remaining life reaches 0.0%, replace the SSD unit with a new one.
Buzzer Off
When [Buzzer] is selected for the alert notification method, you can stop the
buzzer by clicking [Buzzer Off].
Reset
When an alert is detected, clicking [Re s et] recovers the System Monitor
from the “alert” status.
• After an alert is resolved, make sure to reset. If reset is not performed, the alert
history remains, which causes the alert to be detected again eve n if it was
resolved. For alert recovery procedures, refer to the following section:
Minimize Stores the System Monitor screen in the task tray.
Item Operation
SEE
3.3.4 When an Alert Occurs (page3-15)