Instruction Manual

8
(5) WARNING: Explosion hazard-confirm
that the power supply has been turned
OFF before disconnecting equipment, or
confirm that the location is not subject to
the risk of explosion.
(6) WARNING: Explosion hazard-do not
disconnect equipment unless power has
been switched off or the area is known to
be Non-Hazardous.
(7) In the case of use in Hazardous
Locations, be sure to check that the
externally connected unit and each
interface have been fixed with screws and
locked. In Hazardous Locations, it's
impossible to insert or pull the cable from
the applicable port. Be sure to check that
the location is Non-Hazardous before
inserting or pulling it.
CE Marking
The following units are CE marked products
complying with the EMC Directive.
(EN55011 Class A, EN61000-6-2)
• AGP3300-L1-D24-CA1M
• AGP3300-S1-D24-CA1M
*1
• AGP3300-T1-D24-CA1M
• AGP3400-S1-D24-CA1M
*1
• AGP3400-T1-D24-CA1M
• AGP3500-S1-D24-CA1M
*1
• AGP3500-T1-D24-CA1M
• AGP3600-T1-D24-CA1M
*1 The sales area is limited.
The following units are CE marked products
complying with both the EMC Directive and
low-voltage directive.
(EN55011 ClassA, EN61000-6-2 and EN60950-
1)
• AGP3500-S1-AF-CA1M
*1
• AGP3500-T1-AF-CA1M
• AGP3510-T1-AF-CA1M
*1
• AGP3600-T1-AF-CA1M
*1 The sales area is limited.
Digital Electronics Corporation
8-2-52 Nanko-higashi
Suminoe-ku, Osaka 559-0031
JAPAN
TEL: [phone]
FAX: [phone]
http://www.pro-face.com
© Copyright 2007 Digital Electronics
Corporation. All rights reserved.
INQUIRY
Do you have any questions or com-
ments about your GP?
Please access our site anytime if you
need help with a solution.
http://www.pro-face.com/otasuke/
Please be aware that Digital Electronics
Corporation shall not be held liable by the
user for any damages, losses, or third
party claims arising from the uses of this
product.
Note