Manual

10
• Tightening the screws with too much force
can damage the GP unit’s plastic case.
• The necessary torque is 0.5 N•m.
3. Wiring and attaching/detaching
the AUX connector
• Be sure to remove the AUX Connector from
the GP unit prior to starting wiring. Failure
to do so may cause an electric shock.
 Items Required to Wire Connectors
[Screwdriver]
Recommended type: SDI (Product No.
900837) <Weidmuller Japan>
If another manufacturer is used, be sure
the part has the following dimensions:
point depth: 0.4 mm [0.02 in.]
point height: 2.5 mm [0.10 in.]
length from the point to the handle:
80 mm [3.15 in.]
Point shape should be DIN5264A, and
meet Security Standard DN EN60900.
Also, the screwdriver’s tip should be flat
as indicated in order to access the
narrow hole of the connector:
 Detachment
Turn the tabs on the levers at both ends
of the connector, and the connector is
released from the GP.
 Wiring and attachment
(1) Insert the tip of the screwdriver into
one of the square holes. Then, insert
the cable into the corresponding
round hole. When you pull out the
screwdriver, the cable is locked. For
the pin assignment of the AUX con-
nector, refer to “External Interfaces”.
(2) Insert the wired AUX connector into
the auxiliary I/O or sound output
interface (AUX) the rear (or the
bottom for the AGP-35*0T of the GP
unit). If the connector cannot be fully
inserted, turn the tabs on the levers
at both ends of the connector in the
reverse direction and insert the
connector.
*1 Wire should be AWG 22 to AWG 18 thick, and
twisted.
Applicable wire sizes are UL1015 and UL1007.
*2 Be sure to strip from 6.5 to 8.0 mm [0.26 to
0.31 in.] of cover from the wire.
• Be sure to strip only the amount of
cover required. If too much cover is
removed, the end wires may short
against each other, or against an
electrode, which can create an electric
TOP
Insertion Slots
Bottom
(The figure shows the GP-3500 series.)
Insertion Slot Recess
Hook the fastener on the
Recess,
Panel
Installation Fastener
GP
Hook
and secure the fastener
on the panel with a screw.
Screwdriver Tip
Shape
Wire
*1 *2
Screwdriver
*3