User Manual
11
RED LED illuminates when the internal amplier's output is limited.
NOTE: When this LED ashes reduce the input signal level.
6. PRESET MONITOR/FOH selector
This switch allows the selecon between two equalisaon sengs, suited to two dierent uses.
MONITOR
Suited for stage monitoring sound reinforcement for an improved feedback rejecon.
FOH
This preset has been designed for typical sound reinforcement applicaons with the speaker mounted on oor
stand.
7. POWER switch
Speaker is "ON" when the switch is in the "I" posion..
NOTE: When you shut down your equipment, turn o the speaker rst. When powering up, turn on the speaker last.
8. ON indicator
GREEN LED: when lighted indicates that the amplier has been turned on and AC power is available.
9. LINE VOLTAGE selector
This switch sets the AC voltage line of your country (usually it is set by factory and isn't necessary to change it).
The 115V seng is for mains line in the range of 105-120V~ and 230V seng is for mains line in the range of
210-240V~.
WARNING: an incorrect seng of AC LINE VOLTAGE could damage seriously the internal electronics!
10. AC~ socket
Here’s where you plug in your speaker’s mains supply cord. You should always use the mains cord supplied with the
speaker. Be sure your speaker is turned o before you plug in the cord..
11. FUSE holder
Here is where the mains protecon fuse is placed.
REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.
IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN THEN
CONTACT THE PROEL SERVICE CENTER.