User Manual

RMW8

b) Rear Panel RMW8

1. UP / DOWN

In manual selecting mode, use the Up key to scan the frequency presets from 0 to 99 and Down key from 99 to 0.

2. Menu

Keep pressing the Menu key for 1,5 seconds , it comes to the SQ mode.

3. LOW MID HI

This key controls the AF output Balanced level. Set the key to Low position for –12db output, Mid for –6db, High for 0db.

4. 6.3 Jack Mono Unbalanced audio output

Use a jack mono 6.3 and a shielded unbalance cable.

5. XLR Balanced Audio output

The jack mono output should only be used if the distance between the rmw10 and the mixer / amplifier is not very long.

Use a jack mono 6.3 and a shielded unbalance cable.

6. VDC Power Connector

Connect AC/DC power supply to VDC and ensure to connect previously to the main power supply 220-230Vac.

c) Handheld Transmitter WML

1. Grille for microphone capsule protection

2. Display

Indicates the antenna symbol ( when TX and RX are coupled), operating frequency, battery charge level Channel, (PL) transmission power,

LOCK

3. CH/ON

Pressing for one second to switch on the transmitter. The transmitter displays the current frequency, the battery charge level. Press again to

pass in a cyclic mode the following functions: CHANNEL / PL / LOCK. To disable the transmitter press and keep pressing for one second.

4. SELECT

Functions mode operating allows value selection.

5. Battery location

Unscrew microphone body to insert 2 AA 1,5 V batteries (optional rechargeable) respecting the polarity.

6. Jack input for battery recharge

To recharge rechargeable batteries, connect the battery re-charger (optional) to this jack input.

7. Antenna

If the antenna is covered (by hands for example), the signal can be attenuated with the possibility of signal loss or noise.