User Manual

RMW10

Squelch Control

Enter SQUELCH mode by pressing the MENU key 5 times. The SI symbol with the current level value is displayed:

Number Squelch threshold

1 95,0 dB

2 91,7 dB

3 88,3 dB

4 85,0 dB

5 81,7 dB

6 78,3 dB

7 75,0 dB

8 71,7 dB

9 68,3 dB

10 65,0 dB

Select level using the UP and DN keys and confirm pressing with MEM key.

If the input signal is below the setting level, the receiver is muted .This eliminates background noise during pause times. Ensure to set such

level to avoid to eliminate the signal.

b) Transmitter WMP/WHP

Press for the CH/ON switch for one second to switch the Transmitter on. The transmitter displays the current frequency and the battery

charge level. Press again to pass (in a cyclic mode) to the following functions: CHANNEL - GROUP - PL - LOCK / UNLOCK. To disable the

transmitter press and keep pressing for one second.

Frequency selection

Enter CHANNEL mode, press the CH/ON switch. The CH symbol is displayed along with the current channel value. Use the SELECT button

to select the CHANNEL. Use the CH/ON switch to activate the GROUP mode - the symbol GP will be displayed with the current group value.

Use the SELECT key to select the GROUP. After a few seconds, the display will return to the main menu screen.

RF level Selection

Enter the POWER mode pressing the CH/ON button 3 times. The Symbol PL and the current power value are displayed. Use SELECT key to

select the output power required. 0 = 5dB ,1 = 10dB , 2 = 15dB . After a few seconds, the display will return to the main menu screen.

Lock Function

Enter the LOCK/UNLOCK mode by pressing the CH/ON key 4 times. The Lock or Unlock symbol will be displayed. Use the SELECT key to

select the setting (LOCK/UNLOCK). After a few seconds, the display will return to the main menu screen. When the transmitter is locked, it is

still possible to perform the SCAN function. The display visualise the current setting without allowing any setting modification. When the unit is

locked, only the power on/off, MUTE and LOCK functions are accessible.

Mute function

Press the SELECT button for more than a second will put the unit in MUTE mode.

Pressing the SELECT button again will disable the MUTE function. When the MUTED there will be no audio signal output.

Battery

When batteries are exhausted, the battery level indicator will activate. The batteries should be either replaced or (if rechargeable batteries are

used ) recharged.

Use 1,5V AA Batteries.

To re-charge the batteries, use the optional battery charger with the appropriate connector. Recharging time is generally about 6 hours. While

the batteries are recharging, the battery level indicator is will be animated showing that the system is recharging.