Manualshelf

User Manual

ManualsBrandsProel ManualsAmplificationUHF 551 / 581MHz WIRELESS HEAD MICROPHONE
12345678910
8
17. STATUS LED
This LED shows the status of the transmitter:
OFF: the transmitter is off or is on but muted.
GREEN: the transmitter is on and operative.
18. IR
After removing the battery cover, you can access the infrared port for receiving the channel setting.
19. BATTERY COMPARTMENT
20. ON – OFF – MUTE
Press and hold this button for 3 seconds and you turn on the transmitter ( LED GREEN ). If you press again
the button the transmitter goes in mute ( LED GREEN OFF ). If you press the button for 3 seconds the
transmitter goes off.
RMW1H BODYPACK TRANSMITTER
See FIG. 8 at page 16:
21. ANTENNA
This is the transmitting antenna: do not force, disconnect or try to replace with another one.
22. BATTERIES COVER
Sliding down the lower part of the bodypack you can access the battery inlet and the IR receiver sensor.
23. AUDIO INPUT
T3AF mini XLR input socket to connect the supplied microphone or other microphone.
24. ON – OFF – MUTE BUTTON
Press and hold this button for 3 seconds and you turn on the transmitter ( LED GREEN ). If you press again
the button the transmitter goes in mute ( LED ORANGE ). Press the button for 3 seconds to switch off the
transmitter.
25. STATUS LED
This LED shows the status of the transmitter:
OFF: the transmitter if turned off .
GREEN: the transmitter is on and operative.
ORANGE: the transmitter is on but muted.
26. IR
After removing the battery cover, you can access the infrared port for receiving the channel setting.
27. GAIN SWITCH
With this switch it’s possible to set the gain of the bodypack microphone: set it at 0dB for speaking
voices and at -10dB for singing voices.
OPERATING INSTRUCTIONS
BATTERY REPLACEMENT
For the Battery replacement use always 2x 1.5V AA size LITHIUM or ALKALINE type for the best
performances. You can use also rechargeable batteries but in this case the operating time is shorter. Good
quality ALKALINE batteries guarantee an operating time of about 8 hour.
To replace the batteries on the RMW1M handheld microphone follow the instructions on FIG.3 and 4,
respecting always the polarity marked inside the battery inlet.
To replace the batteries on the RMW1H bodypack microphone follow the instructions on FIG.8 and 9,
respecting always the polarity marked inside the battery inlet.
Always remember to remove the batteries if you don’t use the microphone for a long period of time: this will
avoid the corrosion of the battery contacts.