User Manual

14
OPERATION
After you connected the effect to the mains, the fixture starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards.
Each projector occupies maximum 14 channels. To ensure that the control signals are properly directed
to each PLML575SCNXP, the projector requires addressing. This is to be done for every single projector
by changing the settings on the display.
Please make sure that you don’t have any overlapping channels in order to control each projector
correctly and independently from any other fixture on the DMX data link. If two, three or more projector
is addressed similarly, they will work similarly.
After having addressed all projectors, you may now start operating these via your lighting controller.
NOTE:
After switching on, the projector will automatically detect whether DMX 512 data is received or not. If
there is no data received at the DMX-input, this situation can occur if:
- the 3 PIN XLR plug is not connected with the input of the projector
- the controller is switched off or defective
- the cable or connector is defective
- the signal wires are swap in the input connector
MENU SETTINGS
The fixture is mounted with a LCD display and a rotating knob to select different settings.
Rotate and push to select.
1. VERSION: brand, model, version, number, lamp time, use time.
2. DMX ADDRESS: set address.
3. PAN REVERSE: On (reversed) Off (normal).
4. TILT REVERSE: On (reversed) Off (normal).
5. PAN/TILT SPEED: from 00-15, to set the speed for Pan/Tilt movement.
6. PAN/TILT MODE: 8bit, 16bit, when set as 8bit, the channels Pan fine and Tilt fine will be disabled, the
fixture has 12 channels now.
7. LAMP MODE: On (no control via DMX); Off (control via DMX)