Specifications

32
DEMO OPERATION
The PLML250SE moving head works also without a connection to an external
controller. Press the MODE
MODEMODE
MODE button and select
F4 to enter into the Demo
Operation mode. Press UP
UPUP
UP button and when the display shows
Y . To disable this
function, select
N on the display and press ENTER
ENTERENTER
ENTER to confirm.
RESET
The PLML250SE moving head resets all channels also without a connection to an
external controller. Press the MODE
MODEMODE
MODE button and select
F5 to enter into the Demo
Operation mode. Press UP
UPUP
UP button and when the display shows
Y . To disable this
function, select
N on the display and press E
EE
ENTER
NTERNTER
NTER to confirm.
CONTROLLING
After having addressed all PLML250SE , you may now start operating these via
your lighting controller.
Note:
After switching on, the PLML250SE will automatically detect whether DMX 512
data is received or not. If there is no data received at the DMX-input, the display
will start to flash "A001" with actually set address.
This situation can occur if:
the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with
the input of the PLML250SE, or the controller is switched off or defective.
LAMP
The PLML250SE is to be operated with a HSR 250 or MSR 250 lamp.