Specifications

DMX-CONNECTION

The DMX wires must not come into contact with each other, otherwise the

fixtures will not work at all, or will not work properly.

Use only a stereo shielded cable and 3-pin XLR-plugs and connectors in order to

connect the controller with the fixture or one fixture with another.

DIAGRAM OF THE XLR-CONNECTION:

If you are using the recommended controllers, you can connect the DMX-output

of the controller directly with the DMX-input of the first fixture in the DMX-chain.

If you wish to connect DMX controllers with other XLR-outputs, you need to use

adapter-cables.

BUILDING A DMX-CHAIN:

Connect the DMX-output of the first fixture in the DMX-chain with the DMX-

input of the next fixture. Always connect one output with the input of the next

fixture until all fixtures are connected.

CAUTION:

For all installation, having long signal cables

or in the presence of electrical noise, for

example a discotheque, it is recommended

practice to use a DMX terminator: this assist

in preventing corruption of the digital

control signal by external noise. The DMX

terminator is simply an XLR connector with a

120

Ω

(Ohm) resistor connected across pins

2 and 3, which is then plugged into the OUT

DMX socket on the last projector in the

chain. The connection are illustrated on the

right.

DMX-output

XLR socket

DMX-input

XLR socket