Specifications

27
projector. If you lack these qualifications, do not attempt the installation
yourself, but instead use a professional structural rigger. Improper installation
can result in bodily injury and/or damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists, professional
trussing systems have to be used. The projector must never be fixed swinging
freely in the room.
CAUTION: projectors may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the
projector.
DANGER OF FIRE: when installing the device, make sure there is no highly-
inflammable material (decoration articles, etc.) within a distance of min. 1 m.
CAUTION!
Use 2 appropriate clamps to rig the fixture on the truss. Screw one clamp each
via a M12 screw and nut onto the omega holders. Insert the quick-lock fasteners
of the first omega holder into the respective holes on the bottom of the device.
Tighten the quick-lock fasteners fully clockwise. Install the second omega
holder.
Make sure that the device is fixed properly.
Ensure that the structure (truss) to which you are attaching the fixtures is secure.
The Moving-Head can be placed directly
on the stage-floor or rigged in any
orientation on a truss without altering its
operation characteristics (see the
drawing).
For overhead use, always install a safety-
rope. Pull the safety rope through the ole
on the bottom of the base.
Use a safety rope exclusively as a closed
ring. Never use by only securing at each
end. The maximum drop distance must
never exceeded 20 cm.
A safety rope which already hold the
strain of a crash or which is defective must
not be used again.