User Manual

11
decreasing delay times.
p 50-59. FLANGER – Creates a strong sweeping effect with decreasing times, particularly effective on rock
electric guitar, lead and rhythm.
p 60-69. CHORUS – Provides a soft, ethereal sweeping effect with decreasing times, perfect for
enhancement of electric and acoustic guitar and bass. Also adds a dramatic effect to vocals,
particularly group harmonies and choirs.
p 70-79. DELAY+REV - Typical reverb and echo effect combined together with decreasing times.
p 80-89. FLANGER+REV - Typical reverb and modulation effect combined together with decreasing times.
p 90-99. CHORUS+REV – Typical reverb and modulation effect combined together with decreasing times.
27. FX DISPLAY number
This display shows the number of the currently loaded preset. When rotating the FX selector, the display
scrolls the numbers and flashes until the new preset is confirmed by pressing the FX selector knob.
28. EFFECT MUTE button
Engage this switch if you want to mute the signal outgoing from the internal effect to the MAIN MIX.
29. FX MUTE pedal jack input
You can connect a footswitch (normally open) to MUTE the internal effect (suggested footswitch is PROEL
model GF29).
30. EFFECT PEAK/MUTE detector
This LED shows 2 conditions:
• always lighted = signals that the effect is MUTED.
• flashing = signals a too high input level, near to the overload of the effect input stage that can cause
audible distortion. In this case, reduce the level of the FX sends.
31. FX FADER level control
It adjusts the level of the internal effect signal sent to the MAIN MIX outputs.
32. 2TRK inputs
Use these unbalanced RCA connectors to patch the output of a player, such as an analog tape deck, MP3
player, CD/DVD player or a Personal Computer.
33. USB/2TRK IN level control
It adjusts the level of the 2TRK INPUT and USB input (audio signal from PC).
34. MIX - CH15/16 switch
This switch routes the 2TRK IN or USB input signal directly to MAIN MIX outputs or to the channel 15/16.
When routing the signal to channel 15/16, you can use all the channel’s features before sending the signal to
the MAIN MIX: equalization, aux sends and the internal effect processor.
35. USB/2TRK OUT level control
It adjust the level of signal sent to the 2TRK OUTPUT and to the USB port. This control is picked up before the
MAIN MIX fader control or before the aux1/2 level control, so is independent from the respective level
output controls.