User Manual

8: Burn in

- Connect to the LINE input of the amplifier module the 3:1 pink noise source.

- Connect a 4 Ω 100W resistive load to the LOW amplifier output.

- Connect a 8 Ω 50W resistive load to the HIGH amplifier output.

- Switch ON the amplifier module.

- Increase the pink noise level until the SIGNAL/LIMIT LED is flickering in RED/GREEN light.

- Hold the amplifier in vertical position and run the burn-in test for 2 hours min.

9: Final acoustic check

- After the burn-in test, the amplifier module must still work properly. An acoustic or electric test

(with speaker box and audio signal) is needed to verify this condition.