User Manual

8
• When you power down and turn on again the DIVA speaker the Bluetooth connection is not
automatically restored, but simply pressing again the PAIR button for few seconds the latest
Bluetooth device, if it is within the range and turned on, will be reconnected.
• Use this button also to connect the second DIVA speaker to build a stereo system as specified in
the STEREO LINK instructions.
• To disconnect the DIVA speaker simply press and hold this button until the correspondent LED
lights off. Note that disconnecting a device doesn’t mean unpair it. To unpair your device you
must access the BLUETOOTH menu of the device itself.
NOTE: The Bluetooth connection maximum range is about 10-15 m (30-50 feet) with outright sight.
Each time you turn off the speaker you have to press and hold this button to restore the connection.
8. STEREO LINK
Use this button to link two DIVA loudspeakers to a Bluetooth device to serve as a stereo system. The first
speaker will play the LEFT channel while the second will play the RIGHT channel:
• Connect the first DIVA speaker to the Bluetooth device following the PAIRING procedure above.
This speaker will play initially both channels and only after the procedure is completed it will
play the LEFT channel only.
• In the first DIVA speaker press the STEREO LINK button until its blue LED is flashing.
• In the second DIVA speaker (RIGHT channel) press the PAIR button until the green LED is
flashing.
• In the second DIVA speaker (RIGHT channel) press the STEREO LINK button so that the blue LED
starts flashing. After a few seconds, if the second speaker is within the range of the first speaker,
the STEREO connection is established and the blue LED is permanently on in both speakers. Now
the first DIVA speaker plays the LEFT channel and the second DIVA speaker plays the RIGHT
channel.
NOTE: the STEREO LINK Bluetooth connection maximum range is also about 10-15 m (30-50 feet)
with outright sight.
NOTE: every time you turn off the speakers you must repeat this procedure to restore the STEREO
LINK connection.
9. OUTPUT (XLR)
This male XLR connector provides a balanced line-level signal with the signal of the inputs picked up
before the MASTER and EQ controls, with the option to choose between the mix of the three inputs or
only the first channel using the upper switch. Connect it to the input of another audio system or
powered speaker.
10. MIX OUT / CH1 LINK SWITCH
This switch selects the signal to be sent to the output connector. It can be chosen between the mix of
the three inputs before the MASTER and EQ controls (MIX OUT) or directly the CH1 input signal without
the level control (CH1 LINK).
NOTE: when using two or more DIVA speakers connected in series using the OUTPUT connector the
linked speakers must be connected using CH1 input with its sensitivity set as LINE.
11. EQ HIGH
This knob sets the HIGH TONE level: if rotated clockwise it enhances the high frequencies if rotated
counter clockwise it reduces the high frequencies. The LCD displays both the EQ gain and the EQ
response curve.
12. EQ LOW
This knob sets the LOW TONE level: if rotated clockwise it enhances the low frequencies, if rotated
counter clockwise it reduces the low frequencies. The LCD displays both the EQ gain and the EQ