User Manual
Table Of Contents
- INTRODUCTION
- DESCRIPTION
- MAIN PANEL OPERATIONS
- OPTIONAL ACCESSORIES
- INTRODUZIONE
- DESCRIZIONE
- FUNZIONI DEL PANNELLO PRINCIPALE
- ACCESSORI OPZIONALI
- TECHNICAL SPECIFICATIONS
- DIVA12A TECHNICAL DRAWING
- DIVA15A TECHNICAL DRAWING
- MULTIMEDIA / CONFERENCE CONFIGURATION EXAMPLE
- FOLKSINGER CONFIGURATION EXAMPLE
- STEREO STANDARD CONFIGURATION EXAMPLE
11
Press and rotate the knob to choose the CONFIG menu. Press and rotate again to choose one of the
available options.
Front LED: allows to configure DIVA’s front LED.
• ON (default option): the LED will be permanently
lighted in
BLUE when power is on.
• OFF: the LED will be permanently not lighted when power is off.
• LIMIT: the LED is BLUIE when the speaker is on and will flash in
RED when the DSP is in LIMIT MODE.
LCD Dim: allows to configure the illumination of LCD display.
• NEVER (default option): the display is always lit when the power
is on.
• 30
SECONDS: the display illumination is reduced after 30
seconds of inactivity.
Reset: press to restore all the factory setting.
Exit: press to exit from CONFIG menu.
Press and rotate the knob to choose the INFO option: this page shows the model name and the
firmware version.
15. POWER
Use this switch to power ON or OFF the loudspeaker. It is "ON" when the switch is in the "I" position.
16. AC~ SOCKET
Here’s where you plug in your mains supply cord. You should always use the mains cord supplied with
the device. Be sure that your device is turned off before you plug the mains supply cord into an electrical
outlet.