ProDVX GM-75 Instruction manual www.prodvx.
ProDVX GM-75 Glass Mount Thank you for choosing the ProDVX GM-75 Glass Mount. This is a step-by-step instruction manual to successfully install the ProDVX GM-75 Glass Mount for your 10" display. The ProDVX GM-75 Glass Mount contains the following parts: • • 1 x Glass Mount Cover Sticker 1 x ProDVX GM-75 Mount frame • 2 x adhesive strips • 4 x short VESA screws • 2 x safety screws Please contact support@prodvx.com if you need additional support.
Applying the Glass Mount Cover Sticker 1. Clean the surface, preferably with Pro-Screen Cleaner spray. 2. Affix the Glass Mount Cover Sticker to the glass where the tablet will be placed. 3. Use a solid straight item to even out the Glass Mount Cover Sticker. 4. Even out big bubbles with the straight item (little bubbles will disappear in time). 5. Gently pull down the paper from the front side. 6. Clean the Glass Mount Cover Sticker with Pro-Screen Cleaner spray and let it dry for three minutes.
Mounting your device 7 7. Add the two adhesive strips horizontally to the backside of the ProDVX GM-75 Mount frame and remove the yellow paper from the two adhesive strips. 8. Firmly press the ProDVX GM-75 Mount frame onto the Glass Mount Cover Sticker and hold for ten seconds. 9. Screw the four VESA screws into your 10" display's VESA holes. Tighten the screws by hand as they should stick out a few mm for affixing into the keyholes. 10.
