User's Manual Part 2

33
y After turning on the power switches of the aircraft and the remote controller, you could see the
remaining capacity by observing the LED indicator lights for the aircraft in the remote
controller.
9. Charging
The flight battery cannot be charged while in the aircraft. Please remove it from the aircraft and
charge it with the included charger. It takes about 2.5 hours to finish the charging.
While charging, the LED indicator light in the charger is red. When the light turns solid green, it
means the battery has been fully charged. Please disconnect the charger after the battery is fully
charged.
Ȥ Make sure to use the original charger to charge the battery and the remote controller. GDU will assumes
no responsibilities if faults or damages are caused by not using the original accessories.
Ȥ If the type of the charger plug does not match with that of the power plug, please visit the official store to
buy the same type of the power line before trying to charge.
Remote Controller Preparation
1. ON/OFF
Press the power switch of the remote controller for three seconds, and it will be turned on. Repeat
this operation and the remote controller will be turned off.
2. Battery Check
The battery capacity of the remote controller is shown through the color of the back light of the