User's Manual Part 2

31
4. Battery Installation and Dismounting
A high capacity Li-polymer battery, whose capacity is 6700mAh and voltage is 14.8 V, is used in
this aircraft. The snap joint design is used here and you can snap the battery into the battery cabin
in the direction shown in the following picture. After installation, tighten the cover of the battery
cabin according to the method shown in the following picture.
After flight, please take down the battery according to the method shown in the following picture.
Take down the cover and press the snap joints at two sides of the battery at the same time. You
can dismount the battery.
Ȥ ALWAYS POWER OFF THE AIRCRAFT BEFORE REMOVING THE BATTERY!
Ȥ The battery contains the dangerous chemical. Please read the Battery Safety Guidelines printed on the
surface of the battery carefully before using the aircraft.
5. Gimbal Installation
Insert, with a diagonal angle, the plug of the butt strap of the gimbal into the card slot at the
bottom of the aircraft. Pull to open the snap joint of the spring at the bottom of the aircraft. Press
the other end of the gimbal into the snap joint to connect the gimbal and the bottom surface of the
aircraft. Unclamp the snap joint to check whether the gimbal has been fixedly installed.