User's Manual Part 2

36
Flight
Safety Alarms
1. Environment
y Do not fly in sever whether such as rain, thunder, high wind, snow, heavy fog, and the sand and
dust weather.
y Do not fly between tall buildings. Doing so may lead to disabling of the GPS and affecting flight
characteristics. Please fly in wide open spaces with no buildings or other tall obstacles.
y Always keep the aircraft in direct line of sight and avoid flying over people and water.
y Do not fly in places where there are communication base stations of high-tension cable or launch
towers to avoid the interference of the signals from the remote controller.
y Please visit the FAA.gov website and read “Know Before Your Fly”. This tells you all of the
current hobby flying rules in the US. For example, do not fly above 400 feet in altitude.
y DO NOT FLY NEAR AIRPORTS, HELIPORTS or HOSPITALS.
2. CAUTION
y Do not answer the telephone or make telephone calls while flying the aircraft. Pay close
attention to the display of the APP interface to ensure safe flight.
y Return to base and land as soon as possible when the low battery warning sounds;
y The aircraft will land automatically when the battery reaches critical low voltage. The pilot can
guide the aircraft to a safe landing place though;
y Turn the aircraft off upon landing and before removing the battery.
y In case of an emergency during flight, please use the Return to Home button. DO NOT power
off the motors during flight as the aircraft will come crashing to the ground causing damage and
possible bodily injury.
y The propellers spin at a high rate of speed and can cause serious bodily injury. Please maintain a
safe distance from the spinning motors during operation.
Pre-Check
y Check all parts of the aircraft before each flight. Look for cracks in the propellers, cracks in the
arms and make sure that the motors spin freely. If there is any damage, please repair/replace
before trying to fly the aircraft.
y Make sure the flight battery is fully charged and that the remote control has a good charge
before attempting to fly the aircraft.
y Make sure the arms and landing legs are in their proper places and that the propellers are
properly installed.
y Check whether the connection between the remote controller and the aircraft is normal.
y Always operate with the latest firmware. And check whether the APP and the remote controller
are connected normally.
y Check whether the electric motor and the gimbal are working properly after the aircraft is
powered on.
y Make sure that the SD card has been inserted into the camera.