Owner`s manual
Copyright © 2007 IPE Music
Part A. Operation panel
1. Using the Pitch Bend Wheel: The Pitch Bend wheel is used for raising or lowering the
pitch of a voice during performance. The range of pitch values depends on the different
sound generator being used. Please refer to the manuals of your MIDI devices for
information on how to change the Pitch Bend range. To bend up the pitch, please move
the wheel away from you. To bend down the pitch, please move the wheel towards you.
2. Using the Modulation Wheel: It is very common to use the modulation wheel to change
the intensity of effects: mainly Vibrato (pitch change), Tremolo (change the volume), and
Modulation (change the tone). The Modulation wheel produces a vibrato effect shortly
after the sound is generated. It is most effective for voice such as strings and oboe.
3. Data Entry Slide: This slide controller allows you to adjust the following parameters:
Volume, Velocity, Chorus, and Reverb, Pan pot and Aftertouch from your keyboard
directly.
4. Octave Up / Down button: Use these two buttons to shift the active keyboard range one
octave higher, or lower. For example, if you want to change the octave to 2 octaves
lower of range: Press Octave Up button twice.
5. MIDI / SELECT button: Use this button to select different MIDI command on certain key
from keyboard. The Prodipe Midi USB Keyboard 49N provides several groups of MIDI
command as following.
The Prodipe MIDI USB KEYBOARD 49N provides those different groups controls :
A. MIDI Channels group: Pressing MIDI/SELECT button then press the MCH (MIDI Channel)
key allows you to select the transmitting channel for your keyboard. The default
Channel is 1 when keyboard's power is turned on. Pressing the MIDI/SELECT button,
MIDI Channel 2 then MIDI/SELECT button to change the MIDI transmit channel from 1 to
2.
B. Assignment data entry group: Pressing MIDI/SELECT button then press the key of
Aftertouch (or velocity, or reverb depth, or chorus depth, or pan pot, or volume, or CC
data) then move data entry slide allows you to select the transmitting value of the
function. For example, if you want to change the value of after touch: First, press