Product manual

COMMAND DETAILS

standby (p. 69)flash (p. 68)active (p. 68)

system (p. 69)set-default (p. 68)config (p. 68)

active

■ boot active

Note: This command applies to the 8212zl switch only.

Reboot the active management module. The switch starts to boot from the

default ash image. You can select which image to boot from during the

boot process itself. The switch will switchover to the standby management

module. If a second management module is not present in the switch, the

system is rebooted.

config

■ boot system flash < primary | secondary > config < config | new >

Specify conguration le to use on boot.

Supported Values:

■ config

■ new

flash

■ boot system flash < primary | secondary >

Specify boot image to use after reboot.

Supported Values:

■ primary -- Primary flash image.

■ secondary -- Secondary flash image.

Next Available Option:

■ config < config | new > -- Specify configuration file to use on boot.(p. 68)

■ boot set-default flash < primary | secondary >

Specify the default ash boot image.

Supported Values:

■ primary -- Primary flash image.

■ secondary -- Secondary flash image.

set-default

■ boot set-default

Specify the default ash boot image. Sets the default ash for the

next boot to primary or secondary. You will see this message:

“This command changes the location of the default boot. This command

will change the default ash image to boot from <ash chosen>.

Hereafter, ‘reload’ and ‘boot’ commands will boot from <ash chosen>.

Do you want to continue [y/n]?”

bootCommand Line Interface Reference Guide