Product manual

boot
OVERVIEW
Switch ManagementCategory:
managerPrimary context:
reload (page 403)Related Commands
Usage: boot [system [ash <primary|secondary>] [cong FILENAME]]
boot set-default ash <primary|secondary>
boot active
boot standby
Description: Reboot the device. The primary or secondary software image
can be specied to be used during the boot process.
Optionally, a conguration le can be set for this boot.
Parameters:
o set-default- Sets the default ash boot image for next boot.
o active - Causes switchover and reboots the active management
module, if redundancy is enabled and the other module
is present. Reboots the system if redundancy is disabled
or the module is not present.
o standby - Reboots the standby management module.
COMMAND STRUCTURE
boot active -- Reboot the active management module. (p. 68)
boot set-default -- Specify the default flash boot image. (p. 68)
flash < primary | secondary > -- Specify the default flash boot image. (p. 68)
boot standby -- Reboot the standby management module. (p. 69)
boot system -- Allows user to specify boot image to use after reboot. (p. 69)
flash < primary | secondary > -- Specify boot image to use after reboot. (p. 68)
config < config | new > -- Specify configuration file to use on boot. (p. 68)
EXAMPLES
Example: boot
Boot the switch from primary ash with pending conguration changes
in the running-cong le:
ProCurve(cong)# boot
Device will be rebooted, do you want to continue [y/n]? y
Boot from primary ash
Do you want to save current conguration [y/n]?
Example: boot system flash secondary
Reboot the switch from secondary ash when there are no pending conguration changes
in the running-cong le:
ProCurve(cong)# boot system ash secondary
Device will be rebooted, do you want to continue [y/n] ? y
Boot from secondary ash
Do you want to save current conguration [y/n]?
67© 2008 Hewlett-Packard Development Company, L.P.