Product manual

Enter a list of protocols for the current VLAN delimited by commas.
protocols
■ [no] vlan VLAN-ID protocol < IPX | IPv4 | IPv6 | ... >
Set a predened protocol for the current VLAN.
Supported Values:
■ IPX -- IPX Protocol Group
■ IPv4 -- IP version 4 Protocol Group
■ IPv6 -- IP version 6 Protocol Group
■ ARP -- Address Resolution Protocol Group
■ Appletalk -- Appletalk Protocol Group
■ SNA -- System Network Architecture Protocol Group
■ NetBEUI -- Network BIOS Enhanced User Interface Protocol Group
proxy-arp
■ [no] vlan VLAN-ID ip proxy-arp
Usage: [no] ip proxy-arp
Description: Enable/disable proxy ARP. This is a VLAN context command.
It can be called directly from the VLAN context or may follow
the 'vlan VLAN-ID' command prex. When proxy ARP is enabled on
a VLAN, the device responds to ARP requests received on the
VLAN ports when the device knows a route to the requested IP
addresses.
qos
■ [no] vlan VLAN-ID qos
Usage: [no] qos [dscp <000000|000001...111111> | priority <0-7>]
Description: Set VLAN-based priority. The 'dscp' or 'priority' must
be specied if 'no' is not used. Using 'no' congures
the switch not to apply a VLAN priority override to this
VLAN's packets.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Next Available Options:
■ dscp < 000000 | 000001 | 000010 | ... > -- Specify DSCP policy to use. (p. 628)
■ priority < 0 | 1 | 2 | ... > -- Specify priority to use. (p. 646)
querier
■ [no] vlan VLAN-ID ip igmp querier
Usage: [no] ip igmp querier [interval <seconds>]
Description: Specify querier/non-querier capability for the VLAN. IGMP
queries are not sent when the mode is disabled. When
enabled, the device cannot become Querier for the subnet
unless the VLAN has an IP Address (use the 'show ip' command
648© 2008 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide