Product manual
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR
IP address of the protocol server.
Next Available Options:
■ port-num -- UDP port number of the server. (TCP/UDP-PORT) (p. 645)
■ port-name < dns | ntp | netbios-ns | ... > -- (NUMBER) (p. 645)
■ [no] vlan VLAN-ID ip ospf IP-ADDR
Specify the IP address the request is for.
Next Available Options:
■ passive -- Configures an ospf interface as passive. (p. 643)
■ area -- Specify an OSPF area.(p. 622)
■ authentication-key -- Set simple authentication method and key.(p. 623)
■ authentication -- Disable authentication.(p. 623)
■ md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 638)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 626)
■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 627)
■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 630)
■ priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 646)
■ retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 649)
■ transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 652)
■ [no] vlan VLAN-ID ip rip IP-ADDR
Specify the IP address the request is for.
Next Available Options:
■ authentication-type < none | text > -- Set authentication type used on this interface.(p. 624)
■ authentication-key -- Set RIP authentication key (maximum 16 characters).(p. 623)
■ metric < 1 to 15 > -- Set metric for this interface.(p. 638)
■ poison-reverse -- Enable/disable poison reverse on this interface.(p. 645)
■ receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming packets.(p. 649)
■ send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing packets.(p.
651)
■ rip-compatible < V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
packets.(p. 650)
■ vlan VLAN-ID ip pim-dense ip-addr
Usage: ip pim-dense [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-DM packets sent out on this
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP conguration. The default is 'any'.
This command also enable the PIM-DM protocol on the VLAN interface.
Next Available Options:
■ ip-addr -- Specify IP address. (IP-ADDR) (p. 633)
■ any -- Dynamically determine IP address.(p. 622)
634© 2008 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide