Product manual

Usage: ip pim-sparse dr-priority <0-2147483647>

Description: Set the priority value to use on the interface in the Designated

Router election process. Default is 1.

dscp

■ vlan VLAN-ID qos dscp < 000000 | 000001 | 000010 | ... >

Specify DSCP policy to use.

Supported Values:

Binary formatted value from 000000 to 111111

enable

■ [no] vlan VLAN-ID ipv6 enable

Enable IPv6 on an interface and congures an automatically generated link-local addr.

■ [no] vlan VLAN-ID vrrp vrid < 1 to 255 > enable

Usage: [no] vrrp vrid <VRID> enable

Description: Enable/disable operation of the virtual router instance.

The default value is 'disabled'.

eui-64

■ [no] vlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN eui-64

An IPv6 EUI-64 address that can be automatically congured on any interface

fastleave

■ [no] vlan VLAN-ID ip igmp fastleave [ETHERNET] PORT-LIST

Usage: [no] ip igmp fastleave [ethernet] PORT-LIST

Description: Enables or disables IGMP Fast Leaves. When enabled, as soon as

an IGMP Group Leave has been received on a non-cascaded port,

the switch stops forwarding multicast trafc for that group

to that port.

Does not apply to cascaded ports (see ip igmp forcedfastleave).

When disabled, or when the port is cascaded, the regular IGMP

leave time is used (up to 10 seconds when the switch is not

the IGMP Querier).

The default behavior is for IGMP FastLeaves to be enabled.

This feature is congured for ports on a per-VLAN basis.

■ [no] vlan VLAN-ID ipv6 mld fastleave [ETHERNET] PORT-LIST

Usage: [no] ipv6 mld fastleave < port-list >

Description: Enables MLD fast-leaves on the specied ports in the selected VLAN.

The no form of the command disables MLD fast-leave on the specied

ports in the selected VLAN.

vlanCommand Line Interface Reference Guide