Product manual

advertise-interval
■ vlan VLAN-ID vrrp vrid < 1 to 255 > advertise-interval < 1 to 255 >
Usage: vrrp vrid <VRID> advertise-interval <1-255>
Description: Set time interval (in seconds) between sending VRRP advertisement
messages. The default value is one second.
Range: < 1 to 255 >
all
■ [no] vlan VLAN-ID ip ospf all
Process the request for all IP addresses.
Next Available Options:
■ passive -- Configures an ospf interface as passive. (p. 643)
■ area -- Specify an OSPF area.(p. 622)
■ authentication-key -- Set simple authentication method and key.(p. 623)
■ authentication -- Disable authentication.(p. 623)
■ md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 638)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 626)
■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 627)
■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 630)
■ priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 646)
■ retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 649)
■ transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 652)
■ [no] vlan VLAN-ID ip rip all
Process the request for all IP addresses.
Next Available Options:
■ authentication-type < none | text > -- Set authentication type used on this interface.(p. 624)
■ authentication-key -- Set RIP authentication key (maximum 16 characters).(p. 623)
■ metric < 1 to 15 > -- Set metric for this interface.(p. 638)
■ poison-reverse -- Enable/disable poison reverse on this interface.(p. 645)
■ receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming packets.(p. 649)
■ send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing packets.(p.
651)
■ rip-compatible < V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
packets.(p. 650)
■ vlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate lter
■ vlan VLAN-ID monitor all < In | Out | Both >
Monitor all trafc.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
621© 2008 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide