Product manual

■ interface -- Show OSPF interfaces' information(p. 479)

■ link-state -- Show all Link State Advertisements from throughout the areas to which the device

is attached(p. 485)

■ neighbor -- Show all OSPF neighbors in the locality of of the device(p. 492)

■ redistribute -- List protocols which are being redistributed into OSPF(p. 501)

■ restrict -- List routes which will not be redistributed via OSPF(p. 503)

■ traps -- Show OSPF traps enabled on the device(p. 515)

■ virtual-neighbor -- Show all virtual neighbors of the device(p. 518)

■ virtual-link -- Show status of all OSPF virtual links configured(p. 517)

output

■ show bandwidth output

Show outbound guaranteed minimum bandwidth.

Next Available Option:

■ port-list -- Specify ports for which information will be shown. ([ethernet] PORT-LIST) (p. 496)

PARAM-NAME

■ show snmpv3 params PARAM-NAME

Show a specic Target Parameter entry.

params

■ show snmpv3 params

Show SNMPv3 Target Parameters table.

Next Available Option:

■ PARAM-NAME -- Show a specific Target Parameter entry. (ASCII-STR) (p. 494)

peer

■ show ip rip peer

Usage: show ip rip peer [IP-ADDR]

Description: Show RIP peers. Invoked without parameters shows all RIP

peers of the device. If 'IP-ADDR' is specied only

the peer having the address is displayed.

Next Available Option:

■ peer-ip -- Specify IP address of the RIP peer to show. (IP-ADDR) (p. 494)

peer-ip

■ show ip rip peer IP-ADDR

Specify IP address of the RIP peer to show.

showCommand Line Interface Reference Guide